All-New revolutionary Hookah
)
)
)
Hookah - TheUnit 3.0
Operation Manual for TheUnit 3.0
Fill the glass with cold water. The end of the pipe should be about 1cm under water. For cooler smoke you may add some ice cubes.
Turn the pipe with little pressure into the glass in order to assure the seals to be airtight.
Put the pot on the pipe.
Put the sieve over the tobacco. Then put the coal on the sieve with the rounded side downwards.
Put the tobacco into the pot and make sure not to block up the holes. You may suck on the hose to test if the tobacco is not too dense. Do not use too much tobacco because there should be still enough space for the sieve. Tobacco and coal may be purchased at your tobacco retailer. Coal with a 33 mm diameter fits best.
Now put the chimney on the pot.
Light on the coal. If possible use a jet-stream lighter, because it has a hooter flame.
CAUTION: sparks may occur and cause fire.
Wait for approximately 3 minutes until the coal has reached a higher temperature. Now you can suck on the mouthpeace. Blow fresh air from above on the coal if there is only little or no smoke.
Please note: the aluminium parts get very hot. Burn hazard! Do not touch them! Dropping embers may cause fire. The abuse of tobacco causes health injures and must be consumed by respecting the legal regulations.
